Need to assemble your BackEmbrace? Follow the simple step-by-step videos below.

    Step 1.

    Lay your BackEmbrace out with the "be" logo face down on your right-hand side.

    Step 2.

    Fold the "be" logo over so it faces up.

    Step 3.

    Take the end on your right-hand side (keeping the “be” logo facing up) & slide it through slot A.

    Step 4.

    Take the end on your left-hand side, keeping the fastener side facing down, slide it through slot B.

    Keeping the fastener side facing down, continue sliding the end through slot C.

    Step 5.

    Unfold the "be" logo.

    Fasten the ends together.

    Step 6.

    With the ends still fastened together, put your BackEmbrace on as though you’re putting on a vest.

    Step 7.

    Once the straps are over your shoulders, reach behind your back and pull the ends apart.

    Step 8.

    While holding one end in each hand, extend your arms downward at a 45-degree angle. This will help to snug BackEmbrace around your shoulders and minimize any discomfort under your arms.

    Step 9.

    Fasten the ends below your bust line.

    Step 10.

    Adjust the straps over your shoulders for maximum support. Separate the straps for a more personalized fit.